Installation Instructions

nanoLTE S60 AP Hardware Installation Troubleshooting
NANO_INST_43315 v200_0.5 for N4G_2.0 © ip.access Limited 2017 Page 12
Note: The Ethernet port has standard indicator LEDs, showing when the network connection is up
and flashing for network activity.
Connection
Off The AP does not yet have an IP address. This should change
shortly after the AP is switched on.
Red If this LED has previously been Green, Red means that there
is an error, such as the AP losing its IPsec connection with the
security gateway.
Green Flashing Green indicates the AP is acquiring NTP or
connecting to its IPsec Security Gateway. Steady Green
indicates the AP is connected to its serving IPsec security
gateway.
Mode
Green This LED will always be green for the nanoLTE S60 AP, to
indicate that it is operating in LTE mode. This LED may be off
temporarily during startup.
Service
Off The nanoLTE AP is not provisioned, it has no IP address. This
may be a temporary condition when the AP is switched on for
the first time, or after factory reset.
Red Service not available because the AP is administratively
locked (from the NOS).
Red flashing There is an error condition. Usually this means that the cell is
also down.
Flashing green
(1800ms on, 200ms
off), Red off
Cell down, service not available.
Green flashing
(500ms on, 500ms
off), Red off
Cell locked, service not available.
Green flashing(50ms
on, 50ms off), Red off
Normal reboot, when reset button pressed for less than 5
seconds.
Green flashing(50ms
on, 200ms off), Red
off
Factory reset, when reset button pressed for more than 5
seconds.
LED Colour Description