Installation Instructions

nanoLTE S60 AP Hardware Installation Troubleshooting
NANO_INST_43315 v200_0.5 for N4G_2.0 © ip.access Limited 2017 Page 15
To resolve any incorrect provisioned values, correct them in the NOS then perform a factory
reset. The AP will reconnect to the NOS using the default factory configuration and then
obtain the updated configuration.
4.3.1 S60 Factory Reset
1) Use a thin rod to press and hold the reset button, which is accessed through a
small hole under the Ethernet port.
2) Keep the reset button pressed until the Service LED changes from blinking fast
(50ms on, 50ms off) to blinking slowly (50ms on, 200ms off).
The 4G Service LED blinks fast (50ms on, 50ms off) until the factory reset
commences, then it blinks slowly (50ms on, 200ms off). When the factory restore
process is complete, the LED extinguishes and the AP automatically reboots. The
AP will then attempt to re-contact the Redirector via the Internet, in case there is an
updated OLM Package available (for example, if the DOCP for the AP has been
modified and/or there are new certificates for the AP). The AP will then attempt to
reconnect to the specified IPsec Security Gateway and NOS. If the AP is unable to
reconnect to the Redirector, it will use the existing DOCP parameters.
3) See the nanoLTE AP Troubleshooting manual [TRB_43005] for the full AP restart
sequence following a factory reset.