Installation Manual

nanoBTS Installation Manual

Getting Started with BTS Installer

Once these settings have been made they are remembered and will not normally need to

be made again on later runs of BTS Installer on the same computer.

The items that can be set up are:

• Log file directory – this must be set up, but it can alternatively be done as a by-

product of choosing a configuration file

• IP Address – this does not need setting if you are not going to use BTS Installer’s

built-in DHCP server, but if you are going to use the DHCP server then this must be

set up

• Configuration file – this need not be set up unless and until you wish to use a

configuration file