Installation Manual

nanoBTS Installation Manual
nanoBTS and PSU Regulatory Information
© ip.access Ltd Page 46
Ethernet Switch
nanoBTS
nanoBTS
BSC
RJ45 (48v)
~
~
RJ45
PSU φ
φφ
φ
PSU θ
θθ
θ
θ
θθ
θ PSU located at the switch
φ
φφ
φ PSU located at nanoBTS
When using the ip.access model 126A Ethernet Switch and Power Inserter, external PSU’s
are not required, the NanoBTS is connected locally or via site cabling to the powered ports
of the 126.
and 48V Power Inserter
nanoBTS (max qty 7)
BSC
RJ45 (48v)
~
RJ45 (48V)
126A Ethernet Switch
Ethernet
5.2.3.1 nanoBTS - Handbook - Installing the PSU at the Ethernet Switch.
If the 109 PSU is located at the patch panel /output port of the Ethernet switch, it is
important that the 109 PSU is connected exactly as illustrated below (failure to do so may
cause damage to the switch). Ensure that the 109 PSU is placed in a location that is
ventilated and that the connection leads provide no safety hazard.