Installation Manual

nanoBTS Installation Manual

nanoBTS Hardware Installation

2 NANOBTS HARDWARE INSTALLATION

2.1 Purpose and Scope

This chapter documents the procedure used to install the nanoBTS hardware and physical

connections together with applying the base software configuration.

2.2 Warnings and Regulatory Information

For all warnings and regulatory information, please refer to section 5.

2.3 Unpacking

Unpack the nanoBTS and check to see that the unit has not been damaged in transit. Any

damaged units should be returned to the supplier.

Figure 1 - Unpacking the nanoBTS

2.4 Fitting the External Antenna Kit (optional)

2.4.1 139/140 Hardware

Note: When looking at the nanoBTS with the connections facing down and the LED

visible the antenna on the left side is the Transmit antenna and the antenna on

the right side is the Receive antenna.

Note: The RF feeder cable must not be bent sharply as this may result in a degraded

performance.

Remove the plastic covers by removing the top and bottom plates from both ends of the

nanoBTS. Lever gently apart with screwdriver in notch.