Installation Manual

nanoBTS Installation Manual

nanoBTS Hardware Installation

Figure 4 - Fit clamp plate

Repeat the process for the other end of nanoBTS.

2.4.2 165 Hardware

Note: When looking at the front of a 165 nanoBTS with the Ethernet and TIB

connectors facing downwards, the TX antenna is bottom left, the RX antenna is

bottom right and the Network Listen (NWL) antenna is top right.

To fit external antennas, remove the plastic cover from the unit and unscrew the antennas

to expose the SMA connectors. Connect directly to these connectors. The antennas must

be oriented perpendicular to the unit, as shown, so that the cover fits correctly without

stressing the connectors. (The removable antennas for 165C, 165D, 165G and 165 H are

shown in Figure 5 and Figure 7. The removable antennas for 165A and 165B are smaller.

165E and 165F have no removable antennas.)

Figure 5 - 165 nanoBTS removable antennas

Compression

Spring