Installation Instructions

COMPANY CONFIDENTIAL 110#010XA_GDE.doc

- 13 -

2) Position the bracket on the wall and mark the position of the four screw holes. The top

of the bracket

MUST

be positioned uppermost. Ensure that the bracket is level and

sufficient clearance is maintained to allow the unit to be located on the bracket (at

least 80mm from the bracket to the top of wall and 120mm from the side of the

bracket to a side wall). See the diagram below.

80mm min

120mm min

Figure 6 Positioning mounting bracket

3) Drill the four holes in the positions marked in step 2 and insert the wall plugs (if

required). Fix the mounting bracket securely to the wall. The bracket is designed to

allow the nanoBTS unit to be mounted with the connections either to the top or bottom

of the unit.

4) Slide the nanoBTS onto the bracket and ensure that the retaining spring engages into

the indent at the rear of the unit.

5) Record the MAC address from the label against the correct location of the nanoBTS

in the site configuration plan.