Installation Instructions

© ip.access Ltd
COMPANY CONFIDENTIAL 110#010XA_GDE.doc
- 30 -
Appendix 2: Alternative method to set frequency of nanoBTS
oscillator
Start the nanoInstaller. Select from menu File, Open BTS Session
Figure 27 NanoInstaller Opening Screen
Enter the IP address of the nanoBTS that is to be calibrated.
Figure 28 BTS Session
Click OK and wait until the Mode and BTS State boxes indicate idle.
Once the connection is established, select the frequency band from the tool bar.
Note:
The nanoBTS should be powered on for at least 60 minutes before
performing the frequency calibration procedure, in order to allow the oscillator to
reach its normal operating temperature