User's Manual

CHAPTER 3: PROGRAMMING INSTRUCTIONS
Post Installation Checklist
The following table lists the tasks that should be performed upon completing installation.
TABLE 4: POST INSTALLATION CHECKLIST
NO. CHECKLIST ITEM
;
1 Scope out the entire area setup to locate any obvious problem areas.

2 Check antenna routing for safety concerns and near-field boundary setup.

3
Use tie wraps, where possible to ensure that all cables routed in parallel are
bundled together.

4 Perform appropriate testing to ensure base station works properly.


Once installation is complete make sure the area is clear of debris that would prevent proper
airflow and ventilation.
Overview

This section applies to all frequency ranges of the IPSeries Base Stations. Important! The base
station’s IP address must be known prior to performing the procedures in this section.
The programming procedure should be performed when it is necessary to upgrade a base station’s
Firmware or to change the operating parameters to suit the customer’s needs before putting into
complete operation.
HyperTerminal Setup
To communicate and access parameters from the base station, the base station must be connected to a
HyperTerminal session setup on a personal computer.
Perform the following steps to setup the base station for communication with HyperTerminal:
Step 1 Connect the base station and the PC as shown in the figure below.