User's Manual

APPENDIX B: BASE STATION PARAMETERS

516.80540.UM-Rev. D 1-Jun-07 Page 31 of 38

BASE STATION PARAMETERS

PARAMETER DESCRIPTION / VALID VALUES DEFAULT

host interface

Valid Values:

ethernet, status/no status; slip, status/no status

ETHERNET, status

host serial

Sets the baud rate o the serial connection. “Timeout”

specifies, in milliseconds, the time to end the frame if

the end of frame character is not received.

Valid Values:

Baud, parity, data bits, stop bits, timeout=xxx

Baud: 9600/19200/38400/57600/115200; Parity: N,

O, E (None, Odd, or Even); Data bits: 7, 9; Stop bits:

1, 2

115200, n, 8, 1,

200

IPNC Valid Values: xxx.xxx.xxx.xxx (xxx=0 to 255) 172.16.23.191

IPNC query period Valid Values: 0 to 32767 (unit in seconds) 0

Model Base station model name. B64850D25

Modem FEC Valid Values: On/Off On

MTU

Used to set the MTU (maximum transmission unit).

Where “n” is the desired mtu decimal value, 1500

maximum. Unlock the base prior to changing this

parameter. The parameter change takes effect

immediately. When the base receives a packet with a

sizer greater than the set mtu, it returns an ICMP

packet (type=3, code=4) to the source. The original

received packet is discarded.

Recommended Values: 576/1500

1500

noise Show noise floor in dBm for each Receiver.

num timeslots Valid Values: 1 to 64 20

polarity Valid Values: RX+, RX-, TX+, TX- RX+, TX-

reference frequency Valid Values: 1 to 100 MHz 16.800000 MHz

rf ip address

Base station’s virtual hardware IP address. Set this to

an available IP address that is within the IPNC’s

network.

Valid Values: xxx.xxx.xxx.xxx (xxx = 0 TO 255)

192.168.3.1