User's Manual

APPENDIX B: BASE STATION PARAMETERS

516.80540.UM-Rev. D 1-Jun-07 Page 33 of 38

BASE STATION PARAMETERS

PARAMETER DESCRIPTION / VALID VALUES DEFAULT

tunnel address

This is the slip or Ethernet IP Address

Valid Values: xxx.xxx.xxx.xxx/mm (xxx=0 to 255),

mm=netmask in bits)

172.16.23.5/24

tx quiet time Valid Values: 1 to 20 (unit in ms) 5

tx sync time Valid Values: 1 to 20 (unit in ms) 12

tx tail time Valid Values: 1 to 20 (unit in ms) 5

unlock Valid Values: xxxx (xxxx is the OEM password)

uptime Shows time in seconds since last reboot/reset

version Displays the base station’s firmware version.

 Use the command unlock=password entering the appropriate password to enable programming before

issuing any commands above. Also, the base station should be reset by the “reboot” command when no

more commands will be issued.

For changes to parameters not listed in this Appendix, please contact Customer Support.