User's Manual

CHAPTER 1: INTRODUCTION

516.80540.UM-Rev. D 1-Jun-07 Page 7 of 38

External Features

The base station technology is enclosed in a sturdy aluminum case. The external features consist of a

series of connectors in the rear of the base station and light emitting diodes in the front of the base

station, as described in this section.

S The product warranty becomes void if an uncertified or unauthorized individual removes the base

station cover.

Figure 2: Base Station External Connectors (Rear View)

The base station’s rear external features consist of the following connectors and ports:

TABLE 2: EXTERNAL FEATURES (Rear)

FEATURE DESCRIPTION

TX Transmitter antenna connection

RX1/RX2/RX3 Receivers 1, 2, and 3 antenna connections

GPS Port GPS antenna (SMA) connector

BNC

Bayonet Neill Concelman connector used for measuring receiver

sensitivity.

Power Connector 13.8 VDC base station power connector

Serial Port 1 (DB9M) RS232 Serial Line Internet Protocol (SLIP) interface port (115K)

Terminal Connection

(DB9F)

ANSI/TTY Terminal Connection (used for programming)

(9600 bps, no parity, 8-databits, 1-stop bit)

Ethernet Port RJ45 Ethernet 10 Base T interface port