Installation Manual
Table Of Contents
- IPSeries Mobile Radio User Manual
- Document Revision Control
- Table of Contents
- Manual Components
- Chapter 1: Introduction
- Chapter 2: Basic Network Configuration
- Chapter 3: Setup and Configuration Scenarios
- Chapter 4: Production Installation
- Installation Overview
- Installation Instructions
- Post Installation Checklist
- Preliminary Testing and Troubleshooting
- Preliminary Test Procedure and Troubleshooting
- Chapter 5: Programming Instructions
CHAPTER 3: SETUP AND CONFIGURATION SCENARIOS
2003 IPMobileNet, Inc. 15 IPSeries MR User Manual / Rev. A / 08-Apr-03
Mobile Radio Setup Scenarios
The following describes the two (2) methods of setting up a mobile radio in a vehicle:
Mobile Radio-to-Mobile Computer
Mobile Radio-to-VIU-to-Mobile Computer
Mobile Radio-to-Mobile Computer Setup
Figure 7: Mobile Radio-to-Mobile Computer Setup
To setup a mobile radio-to-mobile computer configuration, additional components are required, as listed
in Table 4:
TABLE 4: MOBILE RADIO-TO-MOBLE COMPUTER COMPONENTS REQUIRED FOR
INSTALLATION
QTY
DESCRIPTION
1
IPM Mobile Radio
1
Mobile Computer
1
20-foot serial cable (DB9F – DB9M)
1
Mobile Radio SLIP Port Driver Installation Diskette
If using the mobile radio’s Ethernet feature an Ethernet crossover cable is required to replace 20-
foot serial cable.
To configure the mobile radio and computer for this type of setup, follow the instructions on pages
2 through 17 in the Mobile Computer Setup for Communication with the Mobile Radio
Installation Guide (IPMN p/n: 516.80310.IG) available on the Product Documentation CD.