Installation Manual
Table Of Contents
- IPSeries Mobile Radio User Manual
- Document Revision Control
- Table of Contents
- Manual Components
- Chapter 1: Introduction
- Chapter 2: Basic Network Configuration
- Chapter 3: Setup and Configuration Scenarios
- Chapter 4: Production Installation
- Installation Overview
- Installation Instructions
- Post Installation Checklist
- Preliminary Testing and Troubleshooting
- Preliminary Test Procedure and Troubleshooting
- Chapter 5: Programming Instructions
CHAPTER 4: PRODUCT INSTALLATION
2003 IPMobileNet, Inc. 21 IPSeries MR User Manual / Rev. A / 08-Apr-03
Keep wires routed through the engine compartment away from hot and/or moving
parts.
4. Prior to drilling holes in the engine compartment firewall, inspect both sides to avoid
obstructions.
5. For grounding point, use the engine block or the negative (-) terminal of the vehicle battery.
Ground connection surfaces must be free of paint, rust, and other corrosion to maximize
performance and avoid damage. Do not tie to the vehicle chassis.
6. To simplify troubleshooting problems, label all connecting points and wires.
Mounting the Mobile Radio
To mount the mobile radio, perform the following steps:
Step 1 As shown in Figure 10, secure the mobile radio into the trunk compartment. Insert
four (4) sheet metal screws in the mobile radio brackets.
Figure 10: Mobile Radio Mounting
1 If less than four (4) screws are used, the mobile radio can become loose in the trunk
compartment. This may cause the mobile radio not to function properly.
When inserting screws, be careful not to disturb the vehicle’s gas tank.