Installation Manual
Table Of Contents
- IPSeries Mobile Radio User Manual
- Document Revision Control
- Table of Contents
- Manual Components
- Chapter 1: Introduction
- Chapter 2: Basic Network Configuration
- Chapter 3: Setup and Configuration Scenarios
- Chapter 4: Production Installation
- Installation Overview
- Installation Instructions
- Post Installation Checklist
- Preliminary Testing and Troubleshooting
- Preliminary Test Procedure and Troubleshooting
- Chapter 5: Programming Instructions
CHAPTER 4: PRODUCT INSTALLATION
2003 IPMobileNet, Inc. 24 IPSeries MR User Manual / Rev. A / 08-Apr-03
Carling Switch Installation (DPST Heavy Duty Toggle)
To install the switch, perform the following steps:
Step 1 Mount the switch in the selected location.
Step 2 Route and wire a red wire (#12 AWG) from the switch to the Automotive Power Relay
(see Figure 14).
Step 3 Ground the switch by routing and wiring a black wire from the switch to the negative
battery post.
Figure 14: Carling Switch Installation