Installation Manual
Table Of Contents
- IPSeries Mobile Radio User Manual
- Document Revision Control
- Table of Contents
- Manual Components
- Chapter 1: Introduction
- Chapter 2: Basic Network Configuration
- Chapter 3: Setup and Configuration Scenarios
- Chapter 4: Production Installation
- Installation Overview
- Installation Instructions
- Post Installation Checklist
- Preliminary Testing and Troubleshooting
- Preliminary Test Procedure and Troubleshooting
- Chapter 5: Programming Instructions
CHAPTER 4: PRODUCT INSTALLATION
2003 IPMobileNet, Inc. 29 IPSeries MR User Manual / Rev. A / 08-Apr-03
Figure 17: VIU Connections
To connect the VIU power supply, perform the following steps:
Step 1 Route the VIU’s power supply cable from the driver compartment to the trunk
compartment.
Step 2 Connect the red (#12 AWG) wire via an in-line fuse from the VIU power cable to
the relay as shown in Figure 17 above.
Step 3 Attach the black (#12 AWG) wire of the VIU power cable to the ground connection
on the vehicle chassis.