Installation Manual
Table Of Contents
- IPSeries Mobile Radio User Manual
- Document Revision Control
- Table of Contents
- Manual Components
- Chapter 1: Introduction
- Chapter 2: Basic Network Configuration
- Chapter 3: Setup and Configuration Scenarios
- Chapter 4: Production Installation
- Installation Overview
- Installation Instructions
- Post Installation Checklist
- Preliminary Testing and Troubleshooting
- Preliminary Test Procedure and Troubleshooting
- Chapter 5: Programming Instructions
CHAPTER 5: PROGRAMMING INSTRUCTIONS
2003 IPMobileNet, Inc. 38 IPSeries MR User Manual / Rev. A / 08-Apr-03
Enabling Ethernet for Static IP Address Update in the Mobile Radio
The following provides instruction on how to enable the Ethernet port on the mobile radio.
Requirements
This process is performed using Windows 98, 2000, or XP.
The default is the Ethernet port. If Ethernet is original connection it will remain connected there. If
disconnected, the connection will default back to the SLIP port connection. If the SLIP port is
connected and programming is attempted, it immediately switches to the Ethernet connection.
Enabling the Ethernet Port
To enable the Ethernet port, perform the following steps:
Step 1 Press the right mouse button on the Network Neighborhood icon and select Properties.
Figure 23: Properties Selection
Step 2 Select TCP/IP Ethernet Controller click on the Properties button and at the TCP/IP
Properties window click on the IP Address tab.
Figure 24: TCP/IP and Ethernet Controller Properties