Installation Manual
Table Of Contents
- IPSeries Mobile Radio User Manual
- Document Revision Control
- Table of Contents
- Manual Components
- Chapter 1: Introduction
- Chapter 2: Basic Network Configuration
- Chapter 3: Setup and Configuration Scenarios
- Chapter 4: Production Installation
- Installation Overview
- Installation Instructions
- Post Installation Checklist
- Preliminary Testing and Troubleshooting
- Preliminary Test Procedure and Troubleshooting
- Chapter 5: Programming Instructions
CHAPTER 5: PROGRAMMING INSTRUCTIONS
2003 IPMobileNet, Inc. 40 IPSeries MR User Manual / Rev. A / 08-Apr-03
Viewing the Mobile Radio’s Configuration Data
To view the mobile radio’s parameters, perform the following steps:
Step 1 At the desktop, run the IPMN_INVADR by double clicking on the dial-up network
connection shortcut.
Step 2 At the desktop, run the IPMessage Utility by double clicking on the IPMsg shortcut.
The IPMessage window displays.
Step 3 In the left field type the mobile radio’s IP address and press ENTER.
Step 4 In the lower message area type a ? and press ENTER. A list of mobile radio
configuration parameters appears in the upper message window.
Changing the Mobile Radio’s IP Address
To change the mobile radio’s IP address, perform the following steps:
Step 1 At the desktop, run the IPMN_INVADR by double clicking on the dial-up network
connection shortcut, as shown above.
Step 2 At the desktop, run the IPMessage Utility by double clicking on the IPMsg shortcut,
as shown above. The IPMessage window displays.
Step 3 In the left field type the mobile radio’s IP address and press ENTER.
Step 4 In the right field type a ? and press ENTER. A list of mobile radio configuration
parameters appears in the upper message window.
Step 5 In the right field type unlock=password (entering the appropriate password) and
press ENTER. This command unlocks the mobile radio’s Firmware and grants the
user the authority to change the IP address.
The password is case sensitive.
Step 6 In the right field type ipaddress=NNN.NNN.NNN.NNN replacing the N’s with the
mobile radio’s new IP address.
A line of text containing the mobile radio’s new IP address will appear in the
message window. If there is no response, repeat Steps 5 and 6.
Step 7 Write the new IP address on a label and attach the label to the mobile radio.
Communication with the mobile radio will cease due to the IP address change.
To resume communication with the mobile radio, type the new IP address in
the left field and press ENTER.