User's Manual

SECTION 3: INSTALLATION INSTRUCTIONS
M64450G25-FCCRpt.doc Page 16
Measuring Insertion Loss
To measure Insertion Loss of an unterminated length of coax, perform the following steps:
Step 1 Connect the antenna to be tested to the appropriate Antenna Analyst.
Step 2 Turn on the Antenna Analyst and the Return Loss is displayed in dB to the left of the
VSWR curve.

To switch from the RETL mode to VSWR mode, refer back to the previous set of
instructions.
Step 3 Divide the result by two (2).
Post Installation Checklist
Table 6 lists the tasks that should be performed upon completing installation.
TABLE 6: POST INSTALLATION CHECKLIST
NO. CHECKLIST ITEM
;
1 Scope out the entire vehicle setup to locate any obvious problem areas.

2 Check wiring for safety concerns.

3 Use tie wraps to ensure that all wires routed in parallel are bundled together.

4 Check to see if any wires are exposed.

5
If any wires are exposed, use electrical tape to cover.

When covering wires in the engine compartment, use high-quality
electrical tape.

6
Perform appropriate testing as described in this manual to ensure mobile radio
works properly.

Once installation is completed, remove all debris and restore dismantled parts and rubber mats to
appropriate locations.