User's Manual

SECTION 3: INSTALLATION INSTRUCTIONS
M64450G25-FCCRpt.doc Page 19
Preliminary Testing and Troubleshooting
This section provides a functional preliminary test for the mobile radio once installed. It is used to
determine the condition of new mobile radios before being placed into service.
Checklist of Required Material
The table below provides a checklist of the tools and equipment required to perform the preliminary test
procedure.
TABLE 8: CHECKLIST OF REQUIRED MATERIAL TO PERFORM PRELIMINARY TESTING
NO. REQUIRED TOOLS/EQUIPMENT
;
1
IPSeries High Speed Mobile Radio installed in the vehicle as previously described
in this section

2
A laptop with an available serial communication port and Microsoft Windows 98 or
greater installed

3
IPMobileNet Dial-Up Networking and IPMessage software loaded onto the laptop
(SLIP2IPMN.exe)

4
DC power supply with ammeter, 13.8V, 12 amps or more (Astron VS12M or
equivalent)

5
Corresponding calibrated IPSeries Base Station

6
Internet Protocol Network Controller (IPNC)

7
Two antennae (generic mag mounts) tuned to frequency of transceiver

8
Serial cable DB9M – DB9F connectors (IPMN p/n: 156.0245.020)

9
RF Attenuator 10-20 dB with appropriate wattage rating for transceiver
