User's Manual

SECTION 3: INSTALLATION INSTRUCTIONS
M64450G25-FCCRpt.doc Page 22
# If a message window appears indicating the connection was unsuccessful, perform the following
troubleshooting steps:
1. Ensure the serial and power cables are properly connected.
2. Verify that the mobile radio lock LED (light emitting diode) is on, indicating the mobile radio
has power.
3. Ensure that the SLIP2IPMN dial-up connection is running.
4. If problem persists after retrying, replace the serial cable with one that is known to be
working properly.
Figure 15IPMessage Window
Step 6 In the IPMessage window in the left field, enter the mobile radio’s IP address and
press the [TAB] button. If the mobile radio IP address is not known, enter
255.255.255.255 in the left field.
Step 7 In the right field type a ? and click the [ENTER] button. A list of mobile radio
configuration parameters appears in the upper message window. This verifies
that the IP address is correct, the mobile radio’s serial interface is live, and that
the mobile radio’s microcontroller section is active.
#
If the upper message window only displays “To [IP address] ?”, communication has not been
established. Validate the IP address.
(
Address
)
(
Commands
)