User's Manual

SECTION 4: FACTORY TEST PROCEDURE
M64450G25-FCCRpt.doc Page 27
Test Connections
Test Equipment Setup
The test equipment should be configured as shown in the figure below:
Mobile Radio Connections
Perform the following steps to connect the mobile radio properly:
Step 1 Connect the GPS antenna.
Step 2 Connect a serial cable and launch IPMessage.
Step 3 Connect a load to the transmitter antenna port.
Step 4 Connect the power cable to a voltage source of 13.8 VDC able to deliver 25 amps of
continuous current.
Step 5 Apply power to the mobile radio.
Step 6 Verify the IPMessage connection by entering the “?” in the IPMessage command
field and pressing [ENTER].