User's Manual

SECTION 2: SETUP AND CONFIGURATION METHOD
M64450G25-FCCRpt.doc Page 5
Mobile Radio-to-Mobile Computer Setup and Configuration
The following section describes the setup and configuration method for the mobile radio in a vehicle.
Mobile Radio-to-Mobile Computer Setup
Figure 3: High Speed Mobile Radio-to-Mobile Computer Setup
Additional components are required to setup a mobile radio-to-mobile computer configuration, and are
listed in the following table:
TABLE 2: HIGH SPEED MOBILE RADIO-TO-MOBLE COMPUTER COMPONENTS
REQUIRED FOR INSTALLATION
QTY DESCRIPTION
1 IPSeries High Speed Mobile Radio
1 Mobile Computer
1 20-foot serial cable (DB9F – DB9M)
1 IPMobileNet SLIP Port Driver Installation file (SLIP2IPMN.exe)

If using the mobile radio’s Ethernet feature an Ethernet crossover cable is required to replace the
20-foot serial cable.
To configure the mobile radio and computer for this type of setup, follow the instructions on pages
2 through 17 in the Mobile Computer Setup for Communication with the Mobile Radio
Installation Guide (IPMN p/n: 516.80310.IG) available on the Product Documentation CD.