User's Manual

SECTION 3: INSTALLATION INSTRUCTIONS

M64450G25-FCCRpt.doc Page 7

The table below lists components that are available for purchase through IPMobileNet, Inc.

TABLE 4: MOBILE INSTALLATION ACCESSORIES

QTY DESCRIPTION IPMN PART NUMBER

4 Screws, Self Tapping #10 X 5/8 37040010-10

1 EMI Filter 127.0020.002

1 Timer, 2 hours 150.0127.004

1 Relay 128.0117.001

1 Relay Socket 128.0116.001

2 Butt Connectors #8 AWG 120.0256.001

1 Terminal, Ring #8 AWG, #10 Screw Insulated 120.0127.001

4 Terminal, Ring #18-22 AWG, #10 Screws Insulated 120.0250.004

4 Terminal, Ring #10-12 AWG, #10 Screws Insulated 120.0250.005

4 Terminal, Disconnect #14-16 F 120.0244.002

18 Terminal, Disconnect #10-12 F 120.0244.003

2 Disconnect Tab, Quad Male 200.1377.001

1 Wire, 12 AWG Black, order 5 ft. 156.0242.001

1 Wire, 12 AWG Red, order 44 ft. 156.0242.003

1 Fuse, 15 AMPS ATO 122.0042.003

2 Fuse, 30 AMPS ATO 122.0042.001

3 Fuse Holder, 12 AWG 120.0253.001

1 Switch, Toggle DPST 144.0136.001

1 Diagram, Mobile Installation (included in this manual) 502.80259.52

1 Diagram, Diversity Antenna Mobile Installation Detail (Typical Install) DT450-10-0201

The table below lists the auxiliary equipment required to complete the installation process.

TABLE 5: AUXILIARY EQUIPMENT

QTY DESCRIPTION IPMN PART NUMBER

1 Serial Cable (DB9MF), 20 ft. 156.0245.020

1 Wire, 8 (133/29) AWG VW-1 Red, by foot, order 19.5 ft. 156.0243.003

1 Wire, 8 (133/29) AWG VW-1 Black, by foot, order 19.5 ft. 156.0243.001

2 Mounting Kit, Permanent Hole (MB8UN) 124.0601.001

Antenna, Radome Type, 410-430 MHz, 3dB Gain (requires 1MB8XN

for each antenna)

102.0206.001

Antenna, Radome Type, 430-450 MHz, 3dB Gain (requires 1MB8XN

for each antenna)

102.0206.002

Antenna, Radome Type, 458-470 MHz, 3dB Gain (requires 1MB8XN

for each antenna)

102.0206.003

Antenna, Radome Type, 470-490 MHz, 3dB Gain (requires 1MB8XN

for each antenna)

102.0206.004

Antenna, 5/8 Wave, 490-512 MHz, 3dB Gain (requires 1MB8XN for

each antenna)

102.0199.006