Installation Guide

MDCMR-Guide.doc\4-Sep-03 Page 20 of 20
VIU IP ADDRESS PROGRAMMING
There are two (2) methods of programming the IP Address on the VIU. The first is through the program mode on the VIU and the second is
through IPMessage Utility. NOTE
: The factory default VIU IP Address is 172.16.21.80. The factory default voice server is 172.16.23.200.
VIU IP Address Programming via the VIU VIU IP Address Programming via IPMsg
To change the VIU IP Address via the VIU program mode, perform
the following steps:
Step 1 Enter the program mode by disconnecting the power for
a minimum of ten seconds then reconnecting (if facing
the rear of the VIU the power connector is on the back
lower right-hand side of the VIU).
The indicator lights on the front of the VIU will blink and
the speaker will beep to confirm a successful power up.
Wait until the VIU display goes blank to continue.
Step 2 Quickly press MENU, DOWN to Profile and press
Enter. Press DOWN to IP Address and press Enter
and the current IP Address displays.
Step 3 Immediately
enter the new address:
NNN*NNN*NNN*NNN (replacing the N’s with the
appropriate address).
NOTE
: NNN is between 0 and 255. Delete leading
zeros. Use the star (*) key to represent
periods in the address.
Press the #INDIV key to store the information.
Press Esc/Clr until you have exited the menu.
Step 4 To validate that the IP address was entered correctly,
repeat Steps 1 and 2 above.
To change via the IPMessage Utility, perform the following steps:
Step 1 Disconnect VIU power for ten seconds, then reconnect.
Step 2 To view the IP Address, follow Steps 1 and 2 from the
‘VIU IP Address Programming via the VIU’.
Step 3 Double click the SLIP2IPMN icon to start
the SLIP2IPMN dial-up network connection.
Step 4 Double click on the Shortcut to IPMsg to
start the IPMessage Utility (If a shortcut is not
available, locate via C:\Program Files\
IPMobilenet\IPMsg.)
The IPMessage window displays.
Step 5 In the left field, enter the IP address of the VIU and
press [ENTER].
Step 6 In the right field type a ? and press [ENTER]. This
displays the VIU Configuration.
Step 7 Type UNLOCK=password (entering the appropriate
password) and press [ENTER]
Step 8 Type IPADDRESS=NNN.NNN.NNN.NNN (replacing
the N’s with the appropriate IP Address) and press
[ENTER]
Step 9 In the left field, enter the VIU’s new IP Address.
Step 10 In the right type a ? or IPADDRESS and press
[ENTER].
Step 11 Verify that the IP Address is correct.
Step 12 Close the IPMessage window.
Rear view of VIU
power
connector