User's Manual

SECTION 2: SETUP AND CONFIGURATION METHOD
M64700G25-FCCRpt.doc Page 5
Mobile Radio-to-Mobile Computer Setup and Configuration
The following section describes the setup and configuration method for the high speed mobile radio in a
vehicle.
Mobile Radio-to-Mobile Computer Setup
Figure 3: High Speed Mobile Radio-to-Mobile Computer Setup
Additional components are required to setup a high speed mobile radio-to-mobile computer configuration,
and are listed below in Table 2:
TABLE 2: HIGH SPEED MOBILE RADIO-TO-MOBLE COMPUTER COMPONENTS
REQUIRED FOR INSTALLATION
QTY DESCRIPTION
1 IPSeries High Speed Mobile Radio
1 Mobile Computer
1 20-foot serial cable (DB9F – DB9M)
1 IPMobileNet SLIP Port Driver Installation Diskette (SLIP2IPMN.exe)

If using the high speed mobile radio’s Ethernet feature an Ethernet crossover cable is required to
replace the 20-foot serial cable.
To configure the high speed mobile radio and computer for this type of setup, follow the
instructions on pages 2 through 17 in the Mobile Computer Setup for Communication with the
Mobile Radio Installation Guide (IPMN p/n: 516.80310.IG) available on the Product
Documentation CD.