mac

Commands for Network Port Configuration
104
EAPS(MRPP), Loopback Detection, ULPP are mutually exclusive. If other modules set
STP state, this function can not be set to block mode.
<0-86400>: The interval of recovery after shutdown, the unit is s.
recovery: After a period of time the port can recover Shutdown to UP again.
<0-86400> is the timeout of recovery. For example, if the shutdown of a port happens
after the packet reception rate exceeding the limit, the port will be UP again when the
user-defined timeout expires. The default timeout is 300s, while 0 means the recovery
will never happen.
Command Mode: Interface Mode
Default: There is no control operation for rate-violation.
Usage Guide: This command is mainly used to the control operation after rate-violation.
shutdown or block operation can ensure the normal processing to other tasks of the
switch. This command needs to associate with rate-violation
[broadcast|multicast|unicast|all] <200-2000000> command.
Example: After set the rate-violation of the unicast packet of port 1/8-10 (GB ports) as
10000pps, the port will be block.
Switch(Config)#interface ethernet 1/8-10
Switch(Config-Port-Range)#rate-violation unicast 10000
Switch(Config-Port-Range)#rate-violation control block
3.1.15 remote-statistics interval
This command is not supported by the switch.
3.1.16 show interface
Command: show interface [ethernet <interface-number> | port-channel
<port-channel-number> | vlan <vlan-id> | <interface-name>] [detail]
show interface ethernet status
show interface ethernet counter {packet | rate}
Function: Show information of layer 3 or layer 2 port on the switch
Parameter: <vlan-id> is the VLAN interface number, the value range from 1 to 4094.
<interface-number> is the port number of the Ethernet, status show important
information of all the layer 2 ports. counter {packet | rate} show package number or rate
statistics of all layer 2 ports. <port-channel-number> is the number of the aggregation
interface, <interface-name> is the name of the interface such as port-channel1. [detail]
show the detail of the port.
Command Mode: Admin and Configuration Mode.
Default: Information not displayed by default