mac

Commands for ULDP
119
6.3 debug uldp event
Command: debug uldp event
no debug uldp event
Function: Enable the message debug function to display the event; the no form
command disables this function.
Parameter: None.
Command Mode: Admin Mode.
Default: Disabled.
Usage Guide: Use this command to display all kinds of event information.
Example: Display event information.
Switch#debug uldp event
6.4 debug uldp fsm interface ethernet
Command: debug uldp fsm interface ethernet <IFname>
no debug uldp fsm interface ethernet <IFname>
Function: To enable debugging information for ULDP for the specified interface. The no
form of this command will disable the debugging information.
Parameters: <IFname> is the interface name.
Command Mode: Admin Configuration Mode.
Default: Disabled by default.
Usage Guide: This command can be used to display the information about state
transitions of the specified interfaces.
Example: Print the information about state transitions of interface ethernet 1/1.
Switch#debug uldp fsm interface ethernet 1/1
6.5 debug uldp interface ethernet
Command: debug uldp {hello|probe|echo|unidir|all} [receive|send] interface
ethernet <IFname>
no debug uldp {hello|probe|echo|unidir|all} [receive|send] interface
ethernet <IFname>
Function: Enable the debug function of display the packet details. After that, display
some kinds of the packet details of terminal interface.
Parameter: <IFname>: Name of the interface.
Command Mode: Admin Mode.