mac

Commands for ULDP
120
Default: Disabled.
Usage Guide: Use this command to display the Hello packet details receiving on the
interface Ethernet 1/1.
Switch#debug uldp hello receive interface Ethernet 1/1
6.6 debug uldp packet
Command: debug uldp packet [receive|send]
no debug uldp packet [receive|send]
Function: Enable receives and sends packet debug function, after that. Display the type
and interface of the packet which receiving and sending on the client. The no form
command disables this function.
Parameter: None.
Command Mode: Admin Mode.
Default: Disabled.
Usage Guide: Use this command to display the packet that receiving on each interface.
Switch#debug uldp packet receive
6.7 uldp aggressive-mode
Command: uldp aggressive-mode
no uldp aggressive-mode
Function: To configure ULDP to work in aggressive mode. The no form of this command
will restore the normal mode.
Parameters: None.
Command Mode: Global Configuration Mode and Port Configuration Mode.
Default: Normal mode.
Usage Guide: The ULDP working mode can be configured only if it is enabled globally.
When ULDP aggressive mode is enabled globally, all the existing fiber ports will work in
aggressive mode. For the copper ports and fiber ports which are available after the
configuration is available, aggressive mode should be enabled in port configuration
mode.
Example: To enable ULDP aggressive mode globally.
Switch(config)#uldp aggressive-mode