mac

Commands for ULDP
121
6.8 uldp enable
Command: uldp enable
Function: ULDP will be enabled after issuing this command. In global configuration
mode, this command will enable ULDP for the global. In port configuration mode, this
command will enable ULDP for the port.
Parameters: None.
Command Mode: Global Configuration Mode and Port Configuration Mode.
Default: By default ULDP is not configured.
Usage Guide: ULDP can be configured for the ports only if ULDP is enabled globally. If
ULDP is enabled globally, it will be effect for all the existing fiber ports. For copper ports
and fiber ports which are available after ULDP is enabled, this command should be
issued in the port configuration mode to make ULDP be effect.
Example: Enable ULDP in global configuration mode.
Switch(config)#uldp enable
6.9 uldp disable
Command: uldp disable
Function: To disable ULDP configuration through this command.
Parameters: None.
Command Mode: Global Configuration Mode and Port Configuration Mode.
Default: By default ULDP is not configured.
Usage Guide: When ULDP is disabled globally, then ULDP in all the ports will be
disabled.
Example: To disable the ULDP configuration in global configuration mode.
Switch(config)#uldp disable
6.10 uldp hello-interval
Command: uldp hello-interval <integer>
no uldp hello-interval
Function: To configure the interval for ULDP to send hello messages. The no form of
this command will restore the default interval for the hello messages.
Parameters: <integer>: The interval for the Hello messages, with its value limited
between 5 and 100 seconds, 10 seconds by default.
Command Mode: Global Configuration Mode.