mac

Commands for ULDP
122
Default: 10 seconds by default.
Usage Guide: Interval for hello messages can be configured only if ULDP is enabled
globally, its value limited between 5 and 100 seconds.
Example: To configure the interval of Hello messages to be 12 seconds.
Switch(config)#uldp hello-interval 12
6.11 uldp manual-shutdown
Command: uldp manual-shutdown
no uldp manual-shutdown
Function: To configure ULDP to work in manual shutdown mode. The no command will
restore the automatic mode.
Parameters: None.
Command Mode: Global Configuration Mode.
Default: Auto mode.
Usage Guide: This command can be issued only if ULDP has been enabled globally.
Example: To enable manual shutdown globally.
Switch(config)#uldp manual-shutdown
6.12 uldp recovery-time
Command: uldp recovery-time<integer>
no uldp recovery-time
Function: To configure the interval for ULDP recovery timer. The no form of this
command will restore the default configuration.
Parameters: <integer>: the time out value for the ULDP recovery timer. Its value is
limited between 30 and 86400 seconds.
Command Mode: Global Configuration Mode.
Default: 0 is set by default which means the recovery is disabled.
Usage Guide: If an interface is shutdown by ULDP, and the recovery timer times out, the
interface will be reset automatically. If the recovery timer is set to 0, the interface will not
be reset.
Example: To set the recovery timer to be 600 seconds.
Switch(config)#uldp recovery-time 600