mac

Commands for ULDP
123
6.13 uldp reset
Command: uldp reset
Function: To reset the port when ULDP is shutdown.
Parameters: None.
Command Mode: Globally Configuration Mode and Port Configuration Mode.
Default: None.
Usage Guide: This command can only be effect only if the specified interface is disabled
by ULDP.
Example: To reset all the port which are disabled by ULDP.
Switch(config)#uldp reset
6.14 show uldp
Command: show uldp [interface ethernet<interface-name>]
Function: To show the global ULDP configuration and status information of interface. If
<interface-name> is specified, ULDP configuration and status about the specified
interface as well as its neighbors’ will be displayed.
Parameters: <interface-name> is the interface name.
Command Mode: Admin and Configuration Mode.
Default: None.
Usage Guide: If no parameters are appended, the global ULDP information will be
displayed. If the interface name is specified, information about the interface and its
neighbors will be displayed along with the global information.
Example: To display the global ULDP information.
Switch(config)#show uldp