mac

Commands for LLDP Function
124
Chapter 7 Commands for LLDP
Function
7.1 clear lldp remote-table
Command: clear lldp remote-table
Function: Clear the Remote-table on the port.
Parameters: None.
Default: Do not clear the entries.
Command Mode: Port Configuration Mode.
Usage Guide: Clear the Remote table entries on this port.
Example: Clear the Remote table entries on this port.
Switch(Config-If-Ethernet 1/1)# clear lldp remote-table
7.2 debug lldp
Command: debug lldp
no debug lldp
Function: Enable the debug information of LLDP function, the no operation of this
command will disable the debug information of LLDP function.
Parameters: None.
Default: Disable the debug information of LLDP function.
Command Mode: Admin Mode.
Usage Guide: When the debug switch is enabled, users can check the receiving and
sending of packets and other information.
Example: Enable the debug switch of LLDP function on the switch.
Switch#debug lldp
7.3 debug lldp packets
Command: debug lldp packets interface ethernet <IFNAME>
no debug lldp packets interface ethernet <IFNAME>
Function: Display the message-receiving and message-sending information of LLDP on
the port; the no operation of this command will disable the debug information switch.
Parameters: None.