mac

Commands for LLDP Function
130
7.15 show debugging lldp
Command: show debugging lldp
Function: Display all ports with lldp debug enabled.
Parameters: None.
Default: None.
Command Mode: Admin and Configuration Mode.
Usage Guide: With show debugging lldp, all ports with lldp debug enabled will be
displayed.
Example: Display all ports with lldp debug enabled.
Switch(config)#show debugging lldp
====BEGINNING OF LLDP DEBUG SETTINGS====
debug lldp
debug lldp packets interface Ethernet1/1
debug lldp packets interface Ethernet1/2
debug lldp packets interface Ethernet1/3
debug lldp packets interface Ethernet1/4
debug lldp packets interface Ethernet1/5
=============END OF DEBUG SETTINGS===============
7.16 show lldp
Command: show lldp
Function: Display the configuration information of global LLDP, such as the list of all the
ports with LLDP enabled, the interval of sending update messages, the configuration of
aging time, the interval needed by the sending module to wait for re-initialization, the
interval of sending TRAP, the limitation of the number of the entries in the Remote Table.
Parameters: None.
Default: Do not display the configuration information of global LLDP.
Command Mode: Admin Mode, Global Mode.
Usage Guide: Users can check all the configuration information of global LLDP by using
“show lldp”.
Example: Check the configuration information of global LLDP after it is enabled on the
switch.
Switch(config)#show lldp
-----LLDP GLOBAL INFORMATIONS-----
LLDP enabled port : Ethernet 1/1