mac

Commands for EFM OAM
142
Example: Enable the debugging of refreshing information for all timers of ethernet1/1.
Switch#debug ethernet-oam timer all interface ethernet1/1
10.6 ethernet-oam
Command: ethernet-oam
no ethernet-oam
Function: Enable ethernet-oam of ports, no command disables ethernet-oam of ports.
Parameters: None.
Command Mode: Port mode
Default: Disable.
Usage Guide: N/A.
Example: Enable ethernet-oam of Ethernet 1/4.
Switch(config)#interface ethernet 1/4
Switch(Config-If-Ethernet1/4)#ethernet-oam
10.7 ethernet-oam errored-frame threshold high
Command: ethernet-oam errored-frame threshold high {<high-frames> | none}
no ethernet-oam errored-frame threshold high
Function: Configure the high threshold of errored frame event, no command restores
the default value.
Parameters: <high-frames>, the high detection threshold of errored frame event,
ranging from 2 to 4294967295.
none, cancel the high threshold configuration.
Command Mode: Port mode
Default: none.
Usage Guide: During the specific detection period, serious link event is induced if the
number of errored frame is larger than or equal to the high threshold and the device
notifies the peer by sending Information OAMPDU of which the value of Link Fault flag in
Flags field is 1. Note that the high threshold can not be less than the low threshold.
Example: Configure the high threshold of errored frame event on Ethernet 1/4 to be
3000.
Switch(Config-If-Ethernet1/4)#ethernet-oam errored-frame threshold high 3000