mac

Commands for EFM OAM
143
10.8 ethernet-oam errored-frame threshold low
Command: ethernet-oam errored-frame threshold low <low-frames>
no ethernet-oam errored-frame threshold low
Function: Configure the low threshold of errored frame event, no command restores the
default value.
Parameters: <low-frames>, the low detection threshold of errored frame event, ranging
from 1 to 4294967295.
Command Mode: Port mode
Default: 1.
Usage Guide: During the specific detection period, errored frame event is induced if the
number of errored frame is larger than or equal to the low threshold and the device
notifies the peer by sending event notification OAMPDU. Note that the low threshold can
not be larger than the high threshold.
Example: Configure the low threshold of errored frame event on Ethernet 1/4 to 100.
Switch(Config-If-Ethernet1/4)#ethernet-oam errored-frame threshold low 100
10.9 ethernet-oam errored-frame window
Command: ethernet-oam errored-frame window <seconds>
no ethernet-oam errored-frame window
Function: Configure the detection period of errored frame event, no command restores
the default value.
Parameters: <seconds> is the time for counting the specified frame number, its range
from 5 to 300, unit is 200ms.
Command Mode: Port mode
Default: 5.
Usage Guide: Detect the errored frame number of the port after the time of specific
detection period. If the number of errored frame is larger than or equal to the threshold,
bring the corresponding event and notify the peer through OAMPDU.
Example: Configure the detection period of errored frame event on port1/4 to be 20s.
Switch(Config-If-Ethernet1/4)#ethernet-oam errored-frame window 100