mac

Commands for LLDP-MED
172
port after the switch configured the corresponding no command. Note: LLDP-MED
Capability TLV sent by the port must be configured before sending LLDP-MED Extended
Power-Via-MDI TLV, or else the configuration cannot be successful. If the device does
not support PoE or PoE function of the port is disabled, although configuring this
command, LLDP-MED Extended Power-Via-MDI TLV will not be sent.
Example: Port 19 enables the function for sending LLDP-MED Extended Power-Via-MDI
TLV.
Switch(Config-If-Ethernet1/19)# lldp transmit med tlv extendPoe
13.9 lldp transmit med tlv inventory
Command: lldp transmit med tlv inventory
no lldp transmit med tlv inventory
Function: Configure the specified port to send LLDP-MED Inventory Management TLVs
aggregation, TLVs aggregation includes 7 TLVs, they are Hardware Revision TLV,
Firmware Revision TLV, Software Revision TLV, Serial Number TLV, Manufacturer Name
TLV, Model Name TLV, Asset ID TLV. The no command disables the capability.
Parameter: None.
Default: The function is disabled for sending LLDP-MED Inventory Management TLVs.
Command Mode: Port mode
Usage Guide: After configuring this command, if the port is able to send LLDP-MED
TLV, LLDP packets with LLDP-MED Inventory Management TLVs sent by the port.
However, LLDP packets without LLDP-MED Inventory Management TLVs sent by the
port after the switch configured the corresponding no command. Note: LLDP-MED
Capability TLV sent by the port must be configured before sending LLDP-MED Inventory
Management TLVs, or else the configuration cannot be successful.
Example: Port 19 enables the function for sending LLDP-MED Inventory Management
TLVs.
Switch(Config-If-Ethernet1/19)# lldp transmit med tlv inventory
13.10 lldp transmit med tlv networkPolicy
Command: lldp transmit med tlv networkPolicy
no lldp transmit med tlv networkPolicy
Function: Configure the specified port to send LLDP-MED Network Policy TLV. The no
command disables the capability.
Parameter: None.