mac

Commands for LLDP-MED
173
Default: The function is disabled for sending LLDP-MED Network Policy TLV.
Command Mode: Port mode
Usage Guide: After configuring this command, if the port is able to send LLDP-MED
TLV, LLDP packets with LLDP-MED Network Policy TLV sent by the port. However,
LLDP packets without LLDP-MED Network Policy TLV sent by the port after the switch
configured the corresponding no command. Note: LLDP-MED Capability TLV sent by the
port must be configured before sending LLDP-MED Network Policy TLV, or else the
configuration cannot be successful.
Example: Port 19 enables the function for sending LLDP-MED Network Policy TLV.
Switch(Config-If-Ethernet1/19)# lldp transmit med tlv networkPolicy
13.11 network policy
Command: network policy {voice | voice-signaling | guest-voice |
guest-voice-signaling | softphone-voice | video-conferencing | streaming-video |
video-signaling} [status {enable | disable}] [tag {tagged | untagged}] [vid {<vlan-id>
| dot1p}] [cos <cos-value>] [dscp <dscp-value> ]
no network policy {voice | voice-signaling | guest-voice |
guest-voice-signaling | softphone-voice | video-conferencing | streaming- video |
video-signaling}
Function: Configure the network policy of the port, including VLAN ID, the supported
application (such as voice and video), the application priority and the used policy, and so
on.
Parameters: voice, voice-signaling, guest-voice, guest-voice-signaling, softphone-voice,
video-conferencing, streaming-video and video-signaling: the application types are
supported by the port.
status: Whether the network policy is usable.
enable: Network Policy of the specified application type has been defined,
enable is the default value of the network policy.
disable: Network Policy of the specified application type is unknown, the
fields (such as VLAN ID, L2 priority and DSCP) are ignored, network connection device
will not send TLV of the specified application type.
tag: Configure the specified application to uses tagged or untagged VLAN
method.
tagged: Configure the flow of the specified application to use the tagged
vlan method, here, the fields (such as VLAN ID, Layer2 priority and DSCP value) are
take effect.
untagged: Configure the flow without tag for the specified application, the