mac

Commands for LLDP-MED
174
fields (such as VLAN ID, Layer2 priority) are ignored, only DSCP value field takes effect.
Untagged is the default value of VLAN method.
vid: Configure VLAN ID that the specified application belongs to. When the
peer sends the flow of the specified application, it will tag the notified VLAN ID, or else
the vlan-id value is 1.
vlan-id: Configure the value of VLAN ID, its range from 1 to 4094.
dot1p: Configure the specified application to tag the flow by using 802.1p
priority, at the same time, use vlan 0 to load the flow.
cos: Configure the priority of Ethernet frame for VLAN.
cos-value: Configure the value of Ethernet frame priority for VLAN, its
range from 0 to 7, the default value is 5.
dscp: Configure DSCP of VLAN.
dscp-value: DSCP value input by the user, its range from 0 to 63, the
default value is 46.
Default: No network policy is configured on the port.
Command Mode: Port mode
Usage Guide: User is able to configure the network policy of many kinds on a port, but
their application types cannot repeat, and a kind of network policy corresponds to a
LLDP-MED network policy TLV. If user configures multi-policy for a port, it will send
multi-LLDP-MED network policy TLV to a LLDP packet. If user does not configure any
network policy, no LLDP-MED network policy TLV is sent to LLDP packet.
Example: Configure the network policy with the application type of voice on port 19.
Switch(Config-If-Ethernet1/19)# network policy voice tag tagged vid 2 cos 6 dscp 23
13.12 show lldp
Command: show lldp
Function: Show the global LLDP and LLDP-MED configuration.
Parameter: None.
Default: None.
Command Mode: Admin mode
Usage Guide: None.
Example: Show the global LLDP and LLDP-MED configuration.
Switch#show lldp
-----LLDP GLOBAL INFORMATIONS-----
LLDP has been enabled globally.
LLDP enabled port : Ethernet1/19
LLDP interval :5