mac

Commands for bpdu-tunnel
179
14.6 bpdu-tunnel dot1x
Command: bpdu-tunnel dot1x
no bpdu-tunnel dot1x
Function: Configure the specified port to forward dot1x packets across the tunnel, the
no command cancels the operation.
Parameter: None.
Command Mode: Port mode
Default: Port does not forward any protocol packets across the tunnel.
Usage Guide: Disable dot1x function on the port before configuring this command.
Example: Configure Ethernet 4/5 to forward dot1x packets across the tunnel.
Switch(Config)#in ethernet 4/5
Switch(Config-if-ethernet 4/5)#bpdu-tunnel dot1x