mac

VLAN Configuration
181
Usage Guide: Use this command to enable the debugging of GVRP packet.
Example: Show information of sending and receiving GVRP packet.
Switch(config)#debug gvrp packet receive interface ethernet 1/1
Receive packet, smac 00-21-27-aa-0f-46, dmac 01-80-C2-00-00-21,
length 90, protocol ID:1,attribute type:0x01,
Attribute Index Length Event Value
-------------------- --------- ------- ----------
1 10 joinIn 100
2 10 joinEmpty 140
3 10 leaveIn 150
4 10 leaveEmpty 180
15.1.3 dot1q-tunnel enable
This command is not supported by the switch.
15.1.4 dot1q-tunnel untag add c-tag
This command is not supported by the switch.
15.1.5 dot1q-tunnel selective enable
Command: dot1q-tunnel selective enable
no dot1q-tunnel selective enable
Function: Specify a port to enable selective QinQ, the no command restores the default
value.
Parameter: None.
Command Mode: Port mode
Default: Do not enable selective QinQ.
Usage Guide: Enable selective QinQ command should associates with hybrid mode,
and it should not be used with dot1q-tunnel enable synchronously.
Example: Enable dot1q-tunnel selective enable of port1.
Switch#config
Switch(config)#interface ethernet 1/1
Switch(Config-If-Ethernet1/1)#dot1q-tunnel selective enable