mac

VLAN Configuration
201
Switch(Config-If-Ethernet1/5)# switchport mode trunk
15.2.2 show vlan-translation n-to-1
Command: show vlan-translation n-to-1 [<interface-name>]
Function: Show the port configuration with Multi-to-One VLAN translation.
Parameter: interface-name: Specify the name of the port which will be shown. If there is
no parameter, show all port configurations with this function.
Command Mode: Admin mode.
Default: There is no Multi-to-One VLAN translation information.
Usage Guide: Enable GVRP packet debugging.
Example: Show all port configurations with Multi-to-One VLAN translation function.
Switch# show vlan-translation n-to-1
Interface Ethernet1/1:
vlan-translation n-to-1 enable, vlan 1-4 to 100
vlan-translation n-to-1 enable,vlan 5-8;13 to 101
Interface Ethernet1/2:
vlan-translation n-to-1 enable,vlan 1-4 to 100
15.3 Commands for Dynamic VLAN Configuration
15.3.1 dynamic-vlan mac-vlan prefer
This command is not supported by this switch.
15.3.2 dynamic-vlan subnet-vlan prefer
This command is not supported by this switch.
15.3.3 mac-vlan
Command: mac-vlan mac <mac-addrss> vlan <vlan-id> priority <priority-id>
no mac-vlan {mac <mac-addrss>|all}
Function: Add the correspondence between MAC address and VLAN, namely specify
certain MAC address to join specified VLAN. The no form of this command deletes
all/the correspondence.
Parameter: mac-address is the MAC address which is shown in the form of