mac

VLAN Configuration
203
Default: No protocol joined the VLAN by default.
Usage Guide: The command adds specified protocol into specified VLAN. If there is any
non VLAN label packet from specified protocol enters through the switch port, it will be
assigned with specified VLAN ID and enter the specified VLAN. No matter which port the
packets go through, their belonging VLAN is the same. The command will not interfere
with VLAN labeled data packets. It is recommended to configure ARP protocol together
with the IP protocol or else some application may be affected.
Example: Assign the IP protocol data packet encapsulated by the EthernetII to
VLAN200.
Switch#config
Switch(config)#protocol-vlan etype 2048 vlan 200
15.3.6 show dynamic-vlan prefer
This command is not supported by this switch.
15.3.7 show mac-vlan
Command: show mac-vlan
Function: Display the configuration of MAC-based VLAN on the switch.
Parameter: None.
Command Mode: Admin Mode and other configuration Mode.
Usage Guide: Display the configuration of MAC-based VLAN on the switch.
Example: Display the configuration of the current MAC-based VLAN.
Switch#show mac-vlan
MAC-Address VLAN_ID Priority
------------------ ----------- --------
00-e0-4c-77-ab-9d 2 2
00-0a-eb-26-8d-f3 2 2
00-03-0f-11-22-33 5 5
15.3.8 show mac-vlan interface
Command: show mac-vlan interface
Function: Display the ports at MAC-based VLAN.