mac

Commands for MAC Address Table Configuration
214
Lock Timer
Whether locking timer (timer timeout) is
enabled for the port.
Mac-Learning function
Whether the MAC address learning function
is enabled.
16.2.8 station-movement check
This command is not supported by the switch.
16.2.9 switchport port-security
Command: switchport port security
no switchport port security
Function: Enable MAC address binding function for the port; the no command disables
the MAC address binding function for the port.
Command mode: Port Mode.
Default: MAC address binding is not enabled by default.
Usage Guide: The MAC address binding function and Port Aggregation functions are
mutually exclusive. Therefore, if MAC binding function for a port is to be enabled, the
Port Aggregation functions must be disabled, and the port enabling MAC address
binding must not be a Trunk port.
Example: Enable MAC address binding function for port 1.
Switch(config)#interface Ethernet 1/1
Switch(Config-If-Ethernet1/1)#switchport port security
16.2.10 switchport port-security convert
Command: switchport port-security convert
Function: Converts dynamic secure MAC addresses learned by the port to static secure
MAC addresses, and disables the MAC address learning function for the port.
Command mode: Port Mode.
Usage Guide: The port dynamic MAC convert command can only be executed after the
secure port is locked. After this command has been executed, dynamic secure MAC
addresses learned by the port will be converted to static secure MAC addresses. The
command does not reserve the configuration.
Example: Converting MAC addresses in port 1 to static secure MAC addresses.
Switch(config)#interface Ethernet 1/1
Switch(Config-If-Ethernet1/1)#switchport port-security convert