mac

Commands for QoS
249
or two queues can be set as 0 and must be set at behind.
Example: Configure the queue weight as 1 2 3 4.
Switch(config)#mls qos queue weight 1 2 3 4
18.14 mls qos queue wred
This command is not supported by switch.
18.15 mls qos queue wdrr weight
This command is not supported by switch.
18.16 mls qos queue bandwidth
This command is not supported by switch.
18.17 mls qos trust
Command: mls qos trust dscp
no mls qos trust dscp
Function: Configures port trust; the no command disables the current trust status of the
port.
Parameters: dscp configures the port to trust DSCP value.
Default: Trust CoS value.
Command mode: Port Configuration Mode.
Usage Guide:
trust dscp mode: Set the intp field based dscp-to-intp mapping.
Example: Set trust dscp of port.
Switch(config)#interface ethernet 1/1
Switch(config-if-ethernet1/1)#mls qos trust dscp
18.18 pass-through-cos
This command is not supported by the switch.