mac

Commands for Layer 3 Management
283
21.3.4 debug arp
Command: debug arp {receive|send|state}
no debug arp {receive|send|state}
Function: Enables the ARP debugging function; the “no debug arp
{receive|send|state}” command disables this debugging function.
Parameter: receive the debugging-switch of receiving ARP packets of the switch; send
the debugging-switch of sending ARP packets of the switch; state the debugging-switch
of APR state changing of the switch.
Default: ARP debug is disabled by default.
Command mode: Admin Mode.
Usage Guide: Display contents for ARP packets received/sent, including type, source
and destination address, etc.
Example: Enable ARP debugging.
Switch#debug arp receive
%Jan 01 01:05:53 2006 IP ARP: rcvd, type REQUEST, src 172.16.1.251,
00-e0-4c-88-ad-bc, dst 172.16.1.110, 00-00-00-00-00-00 flag 0x0, pkt type 1, intf
Vlan100.
%Jan 01 01:05:53 2006 IP ARP: rcvd, type REQUEST, src 172.16.1.251,
00-e0-4c-88-ad-bc, dst 172.16.1.110, 00-00-00-00-00-00 flag 0x0, pkt type 1, intf
Vlan100.
e%Jan 01 01:05:53 2006 IP ARP: rcvd, type REQUEST, src 172.16.1.251,
00-e0-4c-88-ad-bc, dst 172.16.1.110, 00-00-00-00-00-00 flag 0x0, pkt type 1, intf
Vlan100.
%Jan 01 01:05:53 2006 IP ARP: rcvd, type REQUEST, src 172.16.1.251,
00-e0-4c-88-ad-bc, dst172.16.1.110, 00-00-00-00-00-00 flag 0x0, pkt type 1, intf
Vlan100.
21.3.5 ip proxy-arp
This command is not supported by the switch.
21.3.6 l3 hashselect
This command is not supported by the switch.
21.3.7 show arp