mac

Commands for DHCP
303
no domain-name
Function: Configures the Domain name for DHCP clients; the “no domain-name”
command deletes the domain name.
Parameters: <domain> is the domain name, up to 255 characters are allowed.
Command Mode: DHCP Address Pool Mode
Default: None
Usage Guide: Specifies a domain name for the client.
Example: Specifying “foxgate.ua" as the DHCP clients’ domain name.
Switch(dhcp-1-config)#domain-name foxgate.ua
26.1.12 hardware-address
Command: hardware-address <hardware-address> [{Ethernet |
IEEE802|<type-number>}]
no hardware-address
Function: Specifies the hardware address of the user when binding address manually;
the “no hardware-address” command deletes the setting.
Parameters: <hardware-address> is the hardware address in Hex; Ethernet |
IEEE802 is the Ethernet protocol type, <type-number> should be the RFC number
defined for protocol types, from 1 to 255, e.g., 0 for Ethernet and 6 for IEEE 802.
Default: The default protocol type is Ethernet,
Command Mode: DHCP Address Pool Mode
Usage Guide: This command is used with the “host” when binding address manually. If
the requesting client hardware address matches the specified hardware address, the
DHCP server assigns the IP address defined in “host” command to the client.
Example: Specify IP address 10.1.128.160 to be bound to the user with hardware
address 00-00-e2-3a-26-04 in manual address binding.
Switch(dhcp-1-config)#hardware-address 00-00-e2-3a-26-04
Switch(dhcp-1-config)#host 10.1.128.160 24
Related Command: host
26.1.13 host
Command: host <address> [<mask> | <prefix-length>]
no host
Function: Specifies the IP address to be assigned to the user when binding addresses
manually; the “no host” command deletes the IP address.
Parameters: <address> is the IP address in decimal format; <mask> is the subnet