mac

Commands for DHCPv6
327
0001000600000005000BBFAA240812
27.22 prefix-delegation pool
Command: prefix-delegation pool <poolname> [lifetime <valid-time>
<preferred-time>]
no prefix-delegation pool <poolname>
Function: To configure prefix delegation name used by DHCPv6 address pool. The no
form of this command deletes the configuration.
Parameters: <poolname> is the name of the address prefix pool, the length name string
should be less than 32. <valid-time> and <preferred-time> are the valid life time and
the preferred life time of the IPv6 address allocated to the clients respectively, in seconds,
and its value is allowed between 1 and 31536000.However <preferred-time> should be
less than <valid-time>, if not configured, the default <valid-time> will be 2592000, while
<preferred-time> will be 604800.
Command Mode: DHCPv6 address pool configuration mode.
Default: The prefix delegation name used by DHCPv6 address pool is not configured.
Usage Guide: This command configures the name of the address prefix pool for
address allocation. If configured, the addresses in the prefix address pool will be
allocated to the clients. This command can be used in association with the ipv6 local
pool command. For one address pool, only one prefix delegation pool can be bound.
When trying to remove the prefix name configuration, the prefix delegation service of the
server will be unavailable, if both the address pool is not associated with the prefix
delegation pool and no static prefix delegation binding is enabled.
Example:
Switch(dhcp-1-config)#prefix-delegation pool abc
27.23 service dhcpv6
Command: service dhcpv6
no service dhcpv6
Function: To enable DHCPv6 server function; the no form of this command disables the
configuration.
Parameter: None.
Default: Disabled.
Command Mode: Global Mode.
Usage Guide: The DHCPv6 services include DHCPv6 server function, DHCPv6 relay