mac

IPv4 Multicast Protocol
383
Function: Configure multicast source control access-list used on interface, the “no ip
multicast source-control access-group <5000-5099>” command deletes the
configuration.
Parameter: <5000-5099>: Source control access-list number.
Default: None
Command Mode: Interface Configuration Mode
Usage Guide: The command configures with only enabling global multicast source
control. After that, it will match multicast data message imported from the interface
according to configured access-list, such as matching: permit, the message will be
received and forwarded; otherwise the message will be thrown away.
Example:
Switch (config)#interface ethernet1/4
Switch (Config-If-Ethernet1/4)#ip multicast source-control access-group 5000
Switch (Config-If-Ethernet1/4)#
Switch(router-msdp)#default-rpf-peer 10.0.0.1 rp-policy 10
33.1.10 multicast destination-control
Command: multicast destination-control
no multicast destination-control
Function: Configure to globally enable multicast destination control, the NO command is
to recover and disable the multicast destination control globally.
Parameters: None.
Default: Disabled.
Command Mode: Global Configuration Mode.
Usage Guide: Only after globally enabling the multicast destination control, the other
destination control configuration can take effect; the destination access list can be
applied to ports, VLAN-MAC and SIP. After configuring this command,
IGMP-SNOOPING and IGMP will match according to the rules mentioned above when
they try to add ports after receiving IGMP-REPORT.
Example:
switch(config)# multicast destination-control
33.1.11 show ip multicast destination-control
Command: show ip multicast destination-control [detail]
show ip multicast destination-control interface <Interfacename>
[detail]
show ip multicast destination-control host-address <ipaddress>