mac

IPv4 Multicast Protocol
393
query-robustness” command restores to the default value.
Parameter: vlan-id: VLAN ID, ranging between <1-4094>
value: ranging between <2-10>
Command Mode: Global mode
Default: 2
Usage Guide: It is recommended to use the default settings. Please keep this configure
in accordance with IGMP configuration as possible if layer 3 IGMP is running.
Example:
Switch(config)#ip igmp snooping vlan 2 query- robustness 3
33.2.18 ip igmp snooping vlan report source-address
Command: ip igmp snooping vlan <vlan-id> report source-address <A.B.C.D>
no ip igmp snooping vlan <vlan-id> report source-address
Function: Configure forward report source-address for IGMP, the “no ip igmp
snooping vlan <vlan-id> report source-address” command restores the default
setting.
Parameter: vlan-id: VLAN ID range<1-4094>;
A.B.C.D: IP address, can be 0.0.0.0.
Command Mode: Global Mode.
Default: Disabled.
Usage Guide: Default configuration is recommended here. If IGMP snooping needs to
be configured, the source address for forwarded IGMP messages can be 0.0.0.0. If it is
required by the upstream that IGMP messages should use the same network address,
the source address of IGMP messages should be configured to be the same with
upstream.
Example:
Switch (config)#ip igmp snooping vlan 2 report source-address 10.1.1.1
33.2.19 ip igmp snooping vlan specific-query-mrsp
Command: ip igmp snooping vlan <vlan-id> specific-query-mrsp <value>
no ip igmp snooping vlan <vlan-id> specific-query-mrspt
Function: Configure the maximum query response time of the specific group or source,
the no command restores the default value.
Parameters: <vlan-id>: the specific VLAN ID, the range from 1 to 4094.
<value>: the maximum query response time, unit is second, the range from